SHARE |
|
applying power to a KIM | by Bill Degnan - 10/02/2008 10:13 |
Regarding applying power to a KIM..I am looking at page 8 of the KIM User Manual.
Have I interpreted the schematic correctly? It appears that I should connect the ground lead of the power supply to pin 1, and connect a +5V wire to pin A. The +12V cassette lead should connect to the pin labeled N on the Application connector. I also have to connect pins K to 1. I would love to see a picture if there is one out there, but I found nothing. I will post one when I am done. Reply |